Could I get some feedback on this diagram? This is what I came up with after doing quite a bit of searching through the forums. I am going to get started on building a light setup and want to have the lights setup so I can switch between only having the fronts on when the rocker switch is pushed up; and then have BOTH front and back on when I flip the rocker switch down.
Does the way I have the diagram drawn up look as though it will work? Or are there issues that I don't see with the way I have it setup?
Also, I am a little confused as to how I would wire the CARLINGSWITCH so that the LED lights up either on top or on the bottom depending on which way I flip the rocker-switch.
I am no expert, so I would appreciate any help that you can give in regards to this setup.
I would like to have a choice between only having the fronts on, or Both front and back on. I am using mainly for docking at night, so most of the time I won't need the rear's on (the rears would be nice to have if interior light is needed).
(Message edited by sinkoumn on January 20, 2007)