I know it's my first post but I'm a longish time lurker...
I've noticed a few people have posted their board builds recently so though I'd add mine to the mix
It's still not quite finished but getting there,
Spec's:
1420 x 445 at midpoint, 300 tips
Approx 3kg (6.6lb) but the next one WILL be lighter, aiming for 2.5kg (5.5lb) or less
10mm concave at midpoint, flat tips
late 3 stage hybrid rocker
wrapped rails at the moment but next board will have PU or ABS rails
Full Carbon Fibre & foam construction using UD, Bi-axial & twill weaves
Foam is 6mm (1/4in) Corecell M80 from Gurit, propper marine foam with decent mechancial properties
This is the foam all measured & cut out with indert positions
Layed up and in the vacuum bag, the next board will have a heated cure in the oven. (The resin I use likes a higher temperature cure cycle)
Demouled and first trim but shows the amount of rocker
Edge to edge concave, should edge well but expect it to be quite unforgiving.
Rocker profile, the camera has skewed the angles a bit as it looks a little squashed
The basic board, first trim done but needs a bit of work to get a decent finish
The concave is quite high so I'm going to have to lay up some extra over the heal/toe of the bindings to ensure it's flat.
Thats it so far
once I've done some more work on it and taken it out for a ride, I'll post up the results
Threaded Mode