Hey guys, I am rewiring my entire stereo due to an incompetent shop that did it the first time but that's a whole other story.
The stereo system is:
2 pairs rev 10's - 1 SD2
2 pairs xs-650's - 1 SD4
1 xxx 12" sub - 1 SD2
All of the above was being powered through 4awg wire. I have about 50' of 2/0 "welding wire" laying around and was wondering If I could use this for the power and ground cable for my stereo system? The wire is very flexible and can pass up to 600 volts through it.
Second question when you are running your Rev 10's do you have them on full or high?
Thanks
|