The center rear section on my Malibu VLS, aluminum honeycomb construction, caved in and is now junk. I have a new piece of Hi-Density Polyethylene. It measures about 28"x57". It also has a hole in it for the table stand. I have the carpet off the old piece. It removed nicely and is ready to go back on the polyethylene. I have my spray adhesive that I know will work. What I dont know is the best way to go about gluing it down. Should I start at one end and work to the other? Or should I start at the hole and work out? Any help will be very much appreciated.
|