Last night I was out on the water and had the dash lights on. The screen was a lot brighter so I went into the setup to see if I could adjust the brightness. I don't know what I hit once in setup but the gauges went into "sweep mode" (according to Malibu customer service). They didn't know what to tell me besides take the dash out. Unplug the connections to the display. Wait, plug back in. And test. Same results. Blank screen. The gauges on the left and right all read. Any advice? Doesn't anyone know if there is a button sequence I could hold or press to reset? Thanks. Everything works but the screen which is good. Although all I do is wakeboard and it will be difficult to get people to drive well without the cruise.