The screws are too long. I've experienced this putting Ronix boots on an LF board. You have 2 options:
1 - If it's only a small gap, go to the hardware store and get a washer or two to make up the difference. This is what I did.
2 - Get shorter screws at the hardware store. Take the existing ones with you and find Stainless Steel M6 screws that are 1/8 to 1/4 inch shorter and that should also work.
edit: actually sounds like the screws might be the wrong thread. What exactly to you mean by "a tiny bit"? If I were you, I would go with option 2 above and just get some screws with proper length.
Last edited by boardjnky4; 12-30-2014 at 6:22 AM.
|