I've got a 2013 x25. I got the wakemakers piggyback ballast kit and have 750 lb fly highs piggybacked into the rear. I noticed that they will fill to full but then after even just leaving the boat sit at the dock for a few hours they are about 1/2 full. Maybe a little Fuller. So I did some reading and think maybe it's because all the plumbing is below the level of the ballast bags. So I ran the fill drain hose that is coming out of the hard tanks old vent and went up under the rub rail as high as I could then back to the the fill/drain hole on the bag. Still have the same problem. Didn't seem to help a bit. It's not leaking anywhere. No bilges kick on and there's nothing wet back there. Only fix I have so far is to put ball valves in line but that's a pain esp if you want to tweak some in between riders or sets. Anyone have any answers here? Wakemakers acted like they had never heard of this problem but I know it happens to more people. The running the line higher was a suggested fix on team talk because apparently that's how they come stock now but it didn't help my situation. And they told me to check my impellers on the pumps and they are all good. Any help or links to helpful threads that I must have missed would be awesome!
|