Quote:
Originally Posted by luxpdr
No they didn't come with mounts, as they wouldn't do any good since they were on a tube tower and i have an illusion tower.
|
If what you have pictured is the pod side of the harness thats wired to the cross over, then what you need is likely with the clamps you didnt get. Since those pods were originally intended for tube mounts, you will not only need the male connector with leads, but possible the non-threaded backing plate for inside the pod, whats in there, is threaded so the tube clamp can bolt to it. Converting to x-mounts requires a non-threaded plate for bolting through the pod into the tower.
In a pinch, replace the connector. for the plate, remove it and drill the threads out to accommodate the bolts.