I have 2012 V226 bought new in 2013. At 39 hours the prop shaft coupler bolts broke. Took it to a shop and they said the bolts just broke and put new ones in. At about 140 hours the bolts broke again. This time the shop replaced the prop shaft, coupler, strut, and realigned the engine. Took it out a week later, it seemed to run fine. Then I took it out the next week, run for 2 hours and broke the prop shaft inside of the coupler. The bolts were fine. The shop replaced the shaft and coupler and tried to realign the engine. But they could not get to align. Measurements are .03, .10, .10, .10 and stated that the motor is maxed out for the alignment. I know I am assed out for having the boat fixed by the manufacturer since they went out of business. Did I really get stuck with a piece of crap? That has never ran for a whole summer. I need help with this.!!!!! I can't even sell it. I would not wish this crap on any other person. Again I pleading for help. Thank you.