Wiring Tower Speakers and Amp
Hey Guys,
Looking for a little advice. Currently running 2 Exile XM7's with an old Exile 400.4 amp (will be using for cabin speakers). Getting ready to install a pair of Exile SXT65q's and change out the Amp to a Exile Harpoon. What is the best way to wire the speakers? Should I wire them in parallel? The wire that is ran is 18ga (was wired when I bought it) should a re-pull wire either 16ga or 14ga? When adding the new amp I need to run new power wire (old 400.4 is on 8ga). It is about 13 feet to the battery I'm planning on using 4ga and 0ga with a distribution block. Which should be the long run 4ga or 0ga? Thanks for taking the time to help me out. |
Well with DC power you always want the thickest wire over distance so 0 ga for your long run.
18ga in tower is a bit small. I would find some 12 or 14ga. |
http://www.rockfordfosgate.com/rftec...calculator.asp
You'd be surprised how little power you lose with speaker wire sizing. For the amp do 0 from the battery to your distro block and then 4 to the amp as short a lead as possible. |
For a 13ft x 2 run for that 2 chnl and 4 chnl amp, the 1/0 ga is fine for the trunk line and then 4 ga to both amp from the distribution block. Besides, I dont think that amp will accept 1/0 ga in the lugs.
Have you considered selling the 6.5" HLCD and go with a single pair of larger HLCD? This would give you what you are after by adding a set of coaxials, and the amp would run at a more comfortable 4 ohm p/chnl. 14ga if you are going to home-run each speaker wire run, or 12 ga down the tower to the amp, if you are going to make the parallel junction up in the tower. |
Thanks for the help so far.
Another question what do everyone use when cover the wire between the tower and the boat? I was thinking upswing a rubber grommet and soming Ike this http://www.cableorganizer.com/nylon/ Pictures would be great. |
Anyone ever use KnuKoncepts wiring?
|
Avoid their Over-sized CCA. It will not fit many terminals of the same GA and it mushrooms something awful when you strip the insulation off.
|
What is a good option for wires without braking the Bank?
|
All times are GMT -7. The time now is 6:10 PM. |