Coupler alignment/bent prop shaft
 

Could the coupler alignment cause the prop shaft to wobble? My shaft seems to be about .5 off .... Or is the shaft bent itself? I hit a tree branch and dinged my prop, bought a new acme and threw it on and it was not vibrating as much but I could feel a very small vibration when under power, threw a dial on the end of the shaft and it's about .5 off so can the alignment of the coupler cause this? Or am I lookin at spending another few hundred to get a new shaft as well :banghead: any help would be awesome.... Thanks guys!

I decided to take the shaft out and it was bent at the very end by the prop, you guys think it's repairable? And if so where do I send it? Thanks!

I replaced a friends on his supra with one of skidm's shafts ..worked out very well

What is skidm??

here ya go

http://www.skidim.com/

Any (most) prop shop can fix it. Get a quote and hold it against the cost of a new one.

Right on guys, thanks!!!